Belt Conveyor Monitoring System Kit #1 (Touchswitch Alignment Sensors)

The Touchswitch™ is an electronic limit switch. When a belt misaligns or a pulley moves over and contacts the sensor, the built in solid-state electronic circuitry detects the lateral force of the belt or pulley and activates a voltage free relay contact. This relay contact is used to immediately alarm and shutdown the machine.

The face of the sensor is made from hardened stainless steel, so that there is virtually no wear when a belt contacts it. The sensor is not affected by dust or material build up and will still work when completely covered by material. Sensors are normally installed in pairs on opposite sides of the machine. Usually a pair of sensors at each pulley is used, but additional pairs can be installed as required. An external test knob allows for quick and simple sensor / system testing.

The sensors can be connected directly to a PLC input, or for greater safety, to a central independent monitoring system, such as the T500 Hotbus or Watchdog Super Elite.

This Belt Conveyor Monitoring System Kit #1 (Touchswitch Alignment Sensors)
Includes: 

1 x WDC4V46C Watchdog Super Elite Monitoring System
4 x ADB20V3C/D3 NTC Type: 3 Inch Probe
4 x TS2V4C Touchswitch (24 VDC)
1 x P8004V10C P800 Proxswitch (Opto-Isolated Bilateral FET Version)
1 x WG1-4B-4 WG1-4B-4 ~ Whirligig® Shaft Sensor Mount
1 x MAG2000 Mag-Con™ Magnetic Connector for Whirligig
2 x KIT-LUG-ADB20 KIT-LUG-ADB20 - NTC Type